Telescoping Square Tubing

Your Versatile Choice In Galvanized, Square, Telescoping Tubing.
Telescoping Square Tubing with or without holes, can be used for almost any application: racks, shelving, ceiling grids, conveyor systems, interior partitions, adjustable platforms, material handling devices, scaffolds, strapping machines, hangers, support members, protective railings, sign supports, etc.
No special welding, tools or assembly procedures are needed!
Download PDF
Suitable for a vast range of applications, Telescoping Square Tubing saves time time and labor.


Added Versatility with Telescoping
The secret to Telescoping Square Tubing versatility is its ability to telescope, allowing smaller sizes to fit smoothly and snugly into the next larger size. This is made possible by high-speed roll forming technology with high-frequency resistance welding. This produces smooth corner welds within very close tolerances, reducing your fabrication costs.
DOT Approved!
Download PDF

DOT Approved!
Material Specifications
- Tubing must be Telescoping Square tubing conforming to manufacturer’s standards.
- Tubing must be corner welded by high-frequency resistance welding and externally scarfed to agree with corner radius.
- Tubing with plain finish is roll -formed from 12 or 14 gauge hot-rolled steel, ASTM A – 1011
- Grade 50, pickled and oiled. Galvanized finish, roll-formed from 12 or 14 gauge hot-rolled steel, galvanized material conforms to ASTM A – 653
- Grade 50. Average minimum yield strength after cold forming is 60,000 PSI.
Available Sizes
Telescoping Square Tubing comes in five sizes, from 1-1/2″ to 2 – 1/2″ square.
Perforated holes are 7/6″ and spaced on 1″ centers. Sections without holes are available.
Telescoping Square Tubing is galvanized per ASTM A -653 G-90, then receives a conversion coating and a clear organic topcoat to prevent rust and corrosion.
Contact Us for More InformationMany Different Uses! Let us help with cutting, welding, and more!
Wall Thickness Tolerance
Permissible variation in wall thickness is + .011, – .005 inches.
Convexity and Concavity
Measured at the center of the flat side, tolerance is ‡ 010 inch applied to the specific size determined at the corner.
Straightness Tolerance
Permissible variation in straightness is 1/16 in 3 feet.
Corner Radii
Standard corner radius is 5/32″ 1/64.
Weld Flash
Weld flash on corner welded square tubing shall permit 9/64″ radius gauge to be placed in the corner.
Telescoping
Consecutive size tubes shall telescope freely for ten feet.
Tubing Without Holes
12′ and 24′ standard lengths in stock. Custom lengths available.
Tubing With Holes
Standard lengths are 10′, 12′, 20′, & 24′. Custom lengths available.
Hole Tolerance
Tolerance on hole size is # 1/64″ on a 7/16″ Hole size: Tolerance on hole spacing 士 1/8” in 10 feet.
